Subject: Problem?
From: Jean-Christophe Soulie (soulie@lil.univ-littoral.fr)
Date: Tue Oct 18 2005 - 16:08:58 CEST
Hi everybody,
I have a little problem while using the sensitivity analysis module of Cormas.
I had and attribute "initialBoatNumber" at the model level. While defining the
simulation parameters, I want to set up this attribute with the 0.25 value. So
I click on class and then on "initialBoatNumber". After I fill the textfield
with the value and click on "Apply and close" twice. And... I get the following
message from Cormas: Unhandled exception: Message not understood: #value.
Is it a Cormas problem or an improper use of it?
Thanks
Note: Cormas version: 28 Feb 2004
-- Jean-Christophe Soulie Laboratoire d'Informatique du Littoral Universite du Littoral Côte d'Opale 50, rue Ferdinand Buisson BP. 719 62219 Calais Cedex